Built by Golfers, for Golfers
DIY-Golf organizes golf club component listings alongside source-scoped compatibility checks and a measurement-first fitting workflow. Exact model identity comes before a fit claim, and combinations outside the current evidence set remain unverified.
Head Weights
Tungsten & Steel • Swing Weight Tuning
Premium Grips
Golf Pride MCC • Winn Grips
Shafts
Graphite & Steel • All Flex Options
Putter Parts
Weights • Face Styles • Grips
A Practical Path from Part Identity to Fit
DIY-Golf brings component discovery and fitting education into one workflow: identify the exact head, shaft, adapter and hardware before making a compatibility or build decision.
Use the compatibility checker for combinations covered by named source material, then record the measurements and test results needed to reproduce a fitting decision. A chart or similar-looking part is a starting clue, not proof.
When evidence is incomplete, we say not verified yet. Current OEM instructions, the exact component markings and a qualified builder take priority over a generic recommendation.
The DIY-Golf Difference
Exact-Part Identification
Match the brand, model generation, club category, handedness, adapter system and hardware before relying on a listing.
Evidence Before a Fit Claim
The compatibility checker returns only verified, incompatible, conditional or not-yet-verified states within its published source boundary.
Measure, Test and Record
Use static measurements as a starting point, validate the build dynamically and record the final specification for later checks.