Golf Club Fitting Guide
A reliable fitting does not choose club length, lie, grip or shaft flex from one number. Start with height, wrist-to-floor and hand size, then validate the starting specifications by hitting shots and comparing launch data, consistency and feel.
Last reviewed:
Direct answer
What is a sound golf-club fitting process?
Use static measurements to establish a starting specification, then test that specification dynamically. PING's published fitting process uses height, wrist-to-floor and hand size as initial inputs, followed by shots and analysis of variables such as ball speed, launch angle, spin rate, feel and consistency. A chart is a starting point, not a final prescription.
- 1. Identify the exact buildRecord the club model, club category, handedness, shaft, adapter system and installed hardware. Similar-looking parts are not proof of compatibility.
- 2. Take static measurementsHeight, wrist-to-floor and hand size can establish an initial length, lie and grip-size range. Do not use height alone.
- 3. Hit and compareTest realistic candidates while observing ball flight, strike pattern, launch conditions, consistency and the golfer's feedback.
- 4. Record the final specificationWrite down measured playing length, lie, loft, grip build, shaft identity and adapter setting so the result can be reproduced and checked.
Primary source: PING Custom Fitting, checked September 19, 2026.
Keep these fitting decisions separate
Swing weight is not shaft flex
They describe different properties. A swing-weight reading cannot be translated into Regular, Stiff or X-Stiff. Record the assembled club's balance separately from the shaft model and flex designation.
Shaft flex needs validation
Swing speed can help choose a starting candidate, but a universal speed-to-flex table cannot account for model-specific profiles, player delivery or feel. Compare actual shafts and keep the exact manufacturer designation.
Grip size starts with the hands
Hand size is a useful starting input. Confirm the finished diameter, comfort and contact rather than assuming one label fits every golfer or grip model.
Length needs more than height
Use height together with wrist-to-floor and build to establish a starting length and lie. Validate the result through strike, delivery and consistency before changing a club.
Before installing a used shaft or adapter
Confirm sleeve-to-head fit separately from shaft suitability and installation readiness. Stop when the exact model, markings, handedness, hardware or current OEM instructions are uncertain.
What this guide can do
- Give you a repeatable order for measuring and testing.
- Separate component identity, static fit and dynamic validation.
- Point you to evidence-bounded compatibility checks.
What this guide cannot do
- Observe your swing or prescribe a final specification remotely.
- Turn one speed, height or letter code into a universal fit.
- Replace current instructions for the exact head, shaft, adapter and hardware.